• 36 W UV lamp ;
• UV Resin Pro ;
• PH Control Pro;
• Color powder of your choice;
• Light powder;
• Sweeper brush
• 3-sided white sanding block;
• File 180/180 ;
• Fini-Plus (top coat);
• Orange stick;
• Prosthesis , Resin Point & miracle bond (if prosthesis).

NAIL PREPARATION :

• Push back and trim cuticles as needed;
• File the nails using the 180/180 file;
• Sand the surface of the nail with the 3-sided white block (the nail must be matt);
• Apply PH Control to all nails and let air dry. (Repeat this step 2 times and do not touch the nails afterwards);
• If there are prostheses: glue the prostheses using the Resin Point, apply the miracle bond to the junction of the prosthesis and the nail and leave to act for 30 seconds and file/sand to create equality using the 180/180 file and the 3-sided white block.
• Reapply PH control. (Repeat this step 2 times and do not touch the nails afterwards).

APPLICATION OF RESIN AND COLOR POWDER:

*to be done finger by finger and finish with the thumbs*

1. Apply UV Resin (like a regular varnish);
2. Sprinkle the colored powder (top-side-side);
3. Tap your finger to remove excess powder;
4. Clean the grooves and cuticles (if there is any overflow);
5. Cook for 30 seconds under the UV lamp;
6. Brush off excess powder;
7. Repeat steps 1 to 6 2 times ;
8. Make the thumbs with the same steps.

FINISHING:

1. Apply UV Resin (like a regular varnish);
2. Sprinkle the light powder (top-side-side);
3. Tap gently to remove excess powder;
4. Clean the grooves & cuticles (if there is any overflow);
5. Cook for 30 seconds under the UV lamp;
6. Brush off excess;
7. Make the thumbs with the previous steps;
8. Sand using the 180/180 file if there are any rough spots;
9. Apply Fini-Plus top coat and cure for 1 minute. Do this step 2 times.

*Important*

• Refrigerate resins after use.
• Do not do your nails outside. Heat, sun and nails do not mix well.